News

Fanuc EDM Filters | EDM Filters for fanuc Wire Cut EDM | Excellent TAGUTI Filter YT-19 Dimension: 340×46×300 mm Pressure Type: Internal Nipple: No Filtration precision: 5 micron Materials: Japanese filtration paper and glue Compatible Machine: SODICK, FANUC, JAPAX MODEL (O,P,Q,R,S,T,V) TAPECUT (WO,W1) TAPECUT (W2,W3,W4) CUTMATE, CUT2-OA ROBOCUT2-0C,2-1C

METAL CONSTRUCTION WITH 5 MICRON FILTER MEDIA THESE WILL FIT SODICK SERIES Q1.11.A SERIES AA SERIES A(300 , 320, 350, 500, 530, 600, 650, 750, 1000) AQ360, AQ550, AQ560, AQ600, AQ700, AQ SERIES BF250, BF275, BF280L, BF320L MODEL：YT-19 Dimension: 340×46×300 mm Pressure Type: Internal Nipple: No Filtration precision: 5 micron Materials: Japanese filtration paper and glue Compatible Machine: SODICK, FANUC, JAPAX

TAGUTI WIRE CUT EDM FILTERS FOR BROTHER | BROTHER EDM FILTERS YT-20 Number YT – 20 Specifications Ф300 * Ф29 * 500㎜ nozzle No Pressure mode External pressure Applicable models MITSUBISHI、BROTHER、MAXI … Filter material Imported special filter paper Glue Imported special glue Filter precision ≤ 5μm Filter area ≥ 13.5m² Filter NET ≥ 6.5kg The highest pressure 198kpa (2.0kgf/cm²) Bursting Strength 296kpa (3.0kgf/cm²) Use

Wire EDM machining (also known as “spark EDM”) works by creating an electrical discharge between the wire or electrode, & the workpiece. As the spark jumps across the gap, material is removed from both the workpiece & the electrode . To stop the sparking process from shorting out, a non conductive fluid or dielectric is also applied. The waste material is removed by the dielectric, and the process

charmilles edm filters | EDM Filters for charmilles | charmilles edm consumables YT-240 Dimension: 340×450 mm Pressure Type: Internal Nipple: No Filtration precision: 5 micron Materials: Japanese filtration paper and glue Compatible Machine: AGIE/CHARMILLES

EDM uses two oppositely charged electrodes namely a machining electrode and a work-piece, and then bring these electrodes closer in dielectric fluid. As the electrodes get close enough, insulation breaks down and a spark will occur, resulting temperature to reach about 12000 degrees Celsius which will melt and vaporize the material. The discharges that reveal the “spark” create the crater-like surface by removing the

What’s the difference between EDM machines and conventional machines？ *One of the advantages of EDM over traditional parts manufacture is that complex shapes are comparatively easier to create. EDMs can be used to machine a wide variety of materials with closer tolerances than conventional machining. Very small delicate pieces can be created without damage due to cutting pressure, and aforementioned cost-effect

Wire EDM Filters for SODICK | SODICK EDM Filter YT-19 Dimension: 340×46×300 mm Pressure Type: Internal Nipple: No Filtration precision: 5 micron Materials: Japanese filtration paper and glue Compatible Machine: SODICK, FANUC, JAPAX

conditions should follow that wire cut EDM work correctly The gap between electrode wire and workpiece should be certainly maintained in a required range. Within this range, not only impulse power can break through insulating liquid to create spark discharging, but also the eroded workpiece can be flushed away after discharging process. If gap is too big, insulating liquid can’t be break through,, and there will be n